| Time (Local) | Phase | Activity | Status | | :--- | :--- | :--- | :--- | | 08:00 | Preparation | Site survey & safety check | ✅ Complete | | 09:30 | Physical Rig | Unboxing & mounting of hardware | ✅ Complete | | 11:00 | Wiring/Power | Primary and backup circuits connected | ⚠️ Delay (see note) | | 13:30 | Configuration | Firmware flash & IP assignment | ✅ Complete | | 15:00 | Calibration | Sensor zeroing & alignment | ✅ Complete | | 16:00 | Test/Launch | Load simulation run | ✅ Pass |
New users often panic when they hear loud cracking noises during their first few cuts. This is completely normal. The sound is simply the die pressing into the plastic cutting pads. Clean the Rollers big shot install
Best regards,
The story of the install didn’t start in the server room; it started three months prior in a windowless "war room" in lower Manhattan. | Time (Local) | Phase | Activity |
An installation is not complete until the system is properly calibrated. Skip this step, and you risk ruining your materials or damaging the internal mechanisms. Clean the Rollers Best regards, The story of