Aqmos R2d272 Installation Verified Jun 2026

Place the unit close to the main water supply inlet. The brine tank should be positioned next to the resin tanks. Step 3: Connecting the Control Valve Apply Teflon tape to the inlet and outlet adapters. Connect the main water line to the inlet of the valve. Connect the household water line to the outlet.

Before beginning the installation, confirm that your site matches the physical and operational footprint of the device. Specification 1,100 mm x 230 mm x 460 mm Resin Volume 18 Liters of premium ion-exchanger resin Maximum Salt Capacity 50 kg (Tablet salt recommended) Softening Capacity 7,200 Liters at an inlet water quality of 10°dH Control Valve Model BNT 1650 Electronic Flow-Controlled Valve Electrical Requirements 230V / 50Hz standard socket (3 Watts consumption) Operating Pressure Range 2.0 bar minimum to 6.0 bar maximum Plumbing Connection 1" AG (Male Thread) standard connection kit Pre-Installation Requirements & Tool Checklist aqmos r2d272 installation verified

: The system tracks water usage and only triggers a cleaning cycle (regeneration) once the preset capacity is reached, typically delaying the start until 2:00 AM to avoid service interruption. Place the unit close to the main water supply inlet

Locate your home's main water isolation valve and turn it completely off. Open the lowest faucets in the house to thoroughly drain remaining water from the internal plumbing lines. Cut into the main cold water delivery line at your chosen installation point. Connect the main water line to the inlet of the valve

Calculate this based on your local water hardness. For the R2D2-72, divide 72 by your input hardness ( raised to the composed with power dH If your water is 20 raised to the composed with power dH , set the capacity to 3. Commissioning & Final Verification Follow these steps to complete the verification process: Air Removal (Backwash):

Designed for households of up to 7 to 9 people , it can soften roughly 7,200 litres of water per regeneration cycle (at 10°dH input hardness).