Hager Controls Bp 10140 Manual _top_ Jun 2026

| Issue | Possible Cause | Suggested Solution | | :--- | :--- | :--- | | Light stays ON continuously | Movement constantly detected; or light threshold setting too high; or device in Test mode | Check for heat sources or vibrations in detection area; adjust response brightness; confirm device is not in test mode | | Light does not turn ON | Light threshold set too low; load not connected; power supply issue; or detection zone not covered | Increase response brightness setting; verify load wiring; check power supply; walk test detection area | | Unexpected switching | Interference from heating/AC systems, cooling lamps, or vibrations | Relocate or shield device from air currents/heating elements; mount away from vibrating surfaces | | KNX device not responding | Incorrect physical address; ETS configuration mismatch; bus connection issue | Check KNX bus wiring; verify device addressing in ETS; reload application software | | Master/slave devices not synchronized | Incorrect wiring; slave devices not in range; parameterization issue | Verify PB/SL wiring between devices; check number of slaves (max ≤10); review ETS parameters |

- manual activation of the outputs on the device possible, building site operation - Status display of the outputs on the device - Device components - Hager hager controls bp 10140 manual

Press and hold the Menu and OK keys simultaneously for 3 seconds to unlock the interface. Factory Reset | Issue | Possible Cause | Suggested Solution

The “BP 10140” model number is often associated with a busbar power supply , control relay interface , or a modular power distribution block used in Hager’s Volta or Arc protection series. Based on common industrial naming conventions: or light threshold setting too high